Die Suche ergab 6 Treffer
- Mi 13. Mai 2020, 13:55
- Forum: Hardware
- Thema: RF1000 Which doesn't want to print properly
- Antworten: 23
- Zugriffe: 5625
Re: RF1000 Which doesn't want to print properly
Hi, Thank you for the response. I ordered the fan and connected it to port X20. The fan works and I'm going to test how to best utilize it. However, I also noticed a (new?) buzzing sound coming from the circuit board once I turn on the printer. To check if this is caused by the newly attached fan I ...
- Mo 11. Mai 2020, 17:00
- Forum: Hardware
- Thema: RF1000 Which doesn't want to print properly
- Antworten: 23
- Zugriffe: 5625
Re: RF1000 Which doesn't want to print properly
Hi, Thank you for the explanation! I printed a calibration cube and cat at the same time to test the effects of the increased layer time. This is still done at 190 °C extrusion with 60 °C bed temperature. However, this still requires glue to stick every time I print something. I clean the print bed ...
- So 10. Mai 2020, 21:58
- Forum: Hardware
- Thema: RF1000 Which doesn't want to print properly
- Antworten: 23
- Zugriffe: 5625
Re: RF1000 Which doesn't want to print properly
Thanks for the responses. I've cleaned the filament lead-in. Lowered the printing speed and altered the start G-code. The F-value of around 5500 seems like a good fit considering the value is usually around 4000 and tops at 5000 on top layers. I might try it with 6500 tomorrow. For some background, ...
- So 10. Mai 2020, 12:23
- Forum: Hardware
- Thema: RF1000 Which doesn't want to print properly
- Antworten: 23
- Zugriffe: 5625
Re: RF1000 Which doesn't want to print properly
For getting the F-Digits I printed the same cube as I did yesterday. This one came out much nicer. I however barely changed anything, says something about the consistency? I've added the filament loading, removed and replaced the filament and turned SenseOffset Autostart on. I also removed the fan a...
- So 10. Mai 2020, 11:28
- Forum: Hardware
- Thema: RF1000 Which doesn't want to print properly
- Antworten: 23
- Zugriffe: 5625
Re: RF1000 Which doesn't want to print properly
Thank you for your responses everyone! I use a new 0,3 mm nozzle but also have a used nozzle available which I assume is 0,5 mm. I've shared my Slic3r settings in the pictures below but I don't think these should gain too much of a focus now considering I can't get a constant extrusion. The filament...
- Sa 9. Mai 2020, 19:48
- Forum: Hardware
- Thema: RF1000 Which doesn't want to print properly
- Antworten: 23
- Zugriffe: 5625
RF1000 Which doesn't want to print properly
Hello everyone, First of all, I want to apologize for making an English post, I hope this is allowed. I've got a secondhand RF1000 that I've been trying to fine-tune for quite a while. Initially, I thought the problems were in the Slic3r settings and I didn't touch the hardware or firmware. Recently...